1、 Glue filling can better heat dissipation. The power supply has several key components with high heat generation: chips, MOS tubes, transformers, rectifier bridges, etc. when the driving power supply works, the temperature of these components will be much higher. However, it is not enough to rely on some simple heat dissipation. The series of antsiji power supply adopts the form of bare board filled with semi glue, which can quickly and evenly increase the heat dissipation area, The heat dissipation will be faster, and we use the potting glue with high heat dissipation coefficient to conduct heat more effectively, which can quickly cool the bare board of the power supply.
2、 The protection of power supply is more guaranteed. After the power supply is filled with glue, it can prevent moisture and dust, slow down the aging speed of components, and effectively improve the safety, stability and durability of the power supply. The different application environments of LED lamps have a very obvious test on the core drive. Especially in the application environment with humidity or dust, the LED drive circuit is greatly affected. Such an environment is likely to cause power failure. For example, in a dusty environment, there are air holes left for the power supply, and the dust can enter the interior of the lamp. The electrical ions generated during the operation of the power supply can easily adsorb the dust. In the case of bare board power supply, the dust adsorption is likely to cause circuit short circuit and explosion. Such a situation can be avoided by a centralized power supply filled with half glue.
3、 The defective rate of the driving power supply is lower. For power supply manufacturers, glue filling will undoubtedly add great difficulty to the possible repair in the future. However, we have strengthened R & D, developed stable power products, strengthened quality control, refined production process, 100% test aging before shipment, and controlled the defect rate to the lowest or even zero. So, we still need to worry about repair.
4、 Filling half glue plays a protective role for components. In the process of transportation and installation by lamp manufacturers, it can avoid many bad problems caused by bumps, and also avoid the bad problems caused by improper operation of a small number of lighting manufacturers' production employees.
